HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 355 / 458

-339
Figure 319: Service Calibration button sequence
3. Press the
Edit Configuration
button.
4. Press the
Next...
button.
5. Press the
Next...
button.
6. Press the
ZT2B
(Z tip to base) button.
7. Enter the calibration value by pressing the
Increment
,
Decrement
and
Next Digit
buttons.
8. When finished, press
Done...
9. Press the
Save and reboot
button.
10. The printer will reboot and return to idle.
11. Perform automatic Z calibration. See
“Z Calibration” on page 338.
Z tip to tip (ZT2T)
ZT2T is the Z distance from the model tip to the support tip. A positive ZT2T
means the support tip is higher than the model tip. If a support layer on top
of model is too thick, add 0.010” to the ZT2T. If a model layer does not
stick to supports, subtract 0.010” from the ZT2T. If unable to calibrate
automatically, this value may need to be set to default in order to proceed
with automatic calibration. The default value is 0.0000”.
1. While the printer is at
Idle
, enter standby mode by pressing the
Standby...
button.
2. Enter the Service Calibration menu by pressing the following button
sequence on the display panel:
3,2,3,3,1
. See Figure 319.
3. Press the
Edit Configuration
button.
NOTE: The value for ZT2B must be between -0.1500” and
0.0000”.
Button 0
Button 1
Button 2
Button 3