HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 445 / 458

-429
Outputs
The outputs dialog contains toggle buttons to control solenoids and motors
that can not be directly controlled on the Control Panel Display. NOTE: It is
suggested, that due to the time required to display switch state changes, that
you use the LEDs on the PDB to verify switch operations.
Get Calibration
The
Get Calibration
button allows a single calibration file to be retrieved
from any printer. This calibration file will also be on the printer Frame ID
chip. This file contains all the factory calibration information, including, but
not limited to: Tip Offset, Tip Depth, Y Lash, X Correction, and the table
calibration .DAT file.
When the button is pressed, a file selection dialog is presented allowing the
assignment of a file name and the selection of a storage location. This file
should be updated any time maintenance is performed that affects the
factory calibration.
Model Latch The check box shows the state of the model (top)
cartridge latch. Checking or unchecking the toggle
button enables or disables the latch.
Motor Enabled The check button shows the state of the model (top)
feed motor solenoid. Checking or unchecking the
toggle button enables or disables the solenoid.
Motor Running The check box shows the state of the model (top)
filament feed motor. Checking or unchecking the
toggle button enables or disables the motor.
Support Latched The check box shows the state of the support
(bottom) cartridge latch. Checking or unchecking the
toggle button enables or disables the latch.
Motor Enabled The check box shows the state of the support
(bottom) feed motor solenoid. Checking or
unchecking the toggle button enables or disables the
solenoid.
Motor Running The check box shows that state of the support
(bottom) filament feed motor. Checking or
unchecking the toggle button enables or disables the
motor.
Door Latch This check box shows the state of the door latch
solenoid. Checking or unchecking the toggle button
enables or disables the latch.
Lights On This check box shows the state of the chamber lights.
Checking or unchecking the toggle button enables
or disables the lights.