HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 62 / 458

-46
Removing a completed part
When the printer has completed building a part, the display will show
Completed
followed by the file name. It will also show
Remove Part
and
Replace Modeling Base
.
1. Open the chamber door.
2. Turn the modeling base retainers down and remove the modeling base
by sliding out and pulling up.
3. Insert a new modeling base by sliding in and pushing down, turn the
retainers up to lock the modeling base in place.
4. Close the chamber door.
5. After you have opened and closed the door, the display will show
Part
Removed?
ONLY after removing the part and replacing the modeling
base, from the display panel press
Yes
.
After you press
Yes
, the display will show the status as
Idle
or
Ready to Build
for the next part in the queue.
Remove a part from the modeling base:
1. After removing the modeling base from the printer, firmly flex the
modeling base back and forth with your hands to loosen the part.
2. Pull the part off of the modeling base or use a putty knife to completely
remove the part.
Removing support material
HP Designjet 3D and HP Designjet Color 3D use soluble support material
which is designed to dissolve in a soap and water based solution. Your part
is left with a smooth and clean finish with the fine details intact. The soluble
support material can be removed by hand with relative ease, but is designed
to be dissolved from your parts for hands free finishing.
GLOVES: The modeling base will be hot, wear gloves when
removing the part from the printer.
CAUTION: If you press
Yes
before removing the part, the
printer can be damaged.
NOTE: Parts are easier to remove from the modeling base when still
warm.
WARNING: Support material is sharp, wear safety glasses and
gloves when removing support material.