HP A7990A - StorageWorks SAN Director 4/16 Blade Switch, Справочник по аппаратуре

Страница: 110 / 144

110 Intelligent blades
Installing and configuring the FR4-18i blade
To configure the FR4-18i, complete the following tasks:
1. ” Insert the FR4-18i blade into the Director ” on page 110
2. ” Configure FCIP and Fibre Channel Routing Services and enable the ports ” on page 111
3. ” Cable the FR4-18i blade ” on page 111
4. ” Recommendations for cable management ” on page 112
Insert the FR4-18i blade into the Director
To install the FR4-18i blade:
1. Select an empty slot in the Director.
2. Make sure the latches on the FR4-18i blade are unscrewed and open.
3. Slide the FR4-18i blade into the open slot.
4. Close and screw the latches and power on the blade using the power switch at the top of the blade.
The FR4-18i blade begins POST. After POST is complete, the firmware version on the blade will
autolevel with the firmware version on the active CP.
5. Verify that the blade power and blade status LEDs are green after the blade has completed booting.
Figure 36 B-Series MP Router blade (FR4-18i) components
Table 28 B-Series MP Router blade (FR4-18i) components
1 Blade power LED 7
ON/OFF slider switch
2 Blade status LED 8 FC port
3 FC port 9 GbE ports (2)
4 Upper ejector 10 Thumb screw
5 Thumb screw 11 Lower ejector
6 FC port status LED 12 FC port status LED
13 GbE port status LED
15
14
13
12
56-0000590-01 Rev A
!
7
6
5
4
3
2
1
0
GE1
GE0
15
14
13
12
11
10
9
8
56-0000590-01 Rev A
!
FR4
18i
3
2
1
0
GE1
GE0
FR4
18i
scale:
5/16" = 1"
scale:
5/16" = 1"
scale:
15/32" = 1"
scale:
15/32" = 1"
1
2
3
4
5
6
7
8
9
10
11
12
13