horsch Terrano 10 FG, Руководство по эксплуатации

Страница: 29 / 42

Lower the machine to the aluminium clips.
Adjust all adjustment points of the frame to
an identical ground clearance.
Adjust the frame parts by the rear tie rods.
For this purpose loosen the lock nut (4) on
the tie rod and keep adjusting the adjustment
screw (2) with the supplied spanner, until
the clearance between frame and ground is
identical at all points and the rear of the frame
is level.
Tie rod
The play between lock nuts (3) and screw (2)
is necessary to allow the tie rod to move in the
bracket and should not be altered.
Adjust the middle frame section horizontally
by the upper link arm.
Lock the setting with the lock nut.







4
3
2
6
7
5
Adjust the adjustment spindles on the support
wheels. Lower the machine to the ground.
Loosen the lock nuts (5 and 7) and adjust
these until the spacers have contact without
clearance.
The support wheels should carry some weight
and the frame should be level. Secure the
adjustment screws again.
Undercarriage adjustment spindle
Checking the basic setting
Lift the machine completely and keep the
control unit under pressure for a moment to
enable levelling of the cylinders.
Insert an aluminium clip of identical thickness
at each of the depth adjustment points
Lower the machine to the aluminium clips.
The frame parts must all be at the same level
and all points must have identical distance to
the ground. Correct the setting as required.






