Honeywell W180, Руководство пользователя

Страница: 29 / 56

29 68-0139
W180 ZONE CONTROL SYSTEM
Fig. 24—Removing the trim ring.
M3507
ALUMINUM
TRACK
TRIM
RING
SCREWDRIVER
3. Mount the Touchpad in a 3-gang junction box or
drywall as follows:
— 3-gang junction box (Fig. 25):
a. Make sure that the location chosen is clear of
studs and other possible obstructions behind the
drywall.
b. Place the 3-gang junction box on the wall at the
selected location and use it as a stencil to outline
the portion of the drywall to be cut away.
c. Cut the opening for the junction box.
d. Mount the junction box in the cutout.
e. Run the 6-wire connecting cable (Belden
®
8742,
for example) from the junction box to the advance
zoning controller, leaving a minimum of 3 in.
[76 mm] of wire exposed in the junction box for
connection to the Touchpad.
f. Connect the four Touchpad signal and power
wires to the 6-wire connecting cable (red wire for
input power, black wire for common, green and
yellow wires for signals) using wire nuts. See
Fig. 26 and 27. If more than three Touchpads are
being wired to the W180A Controller, see Fig. 28
for auxiliary power wiring. If required, connect
the wiring between TotalHome
®
System and W180
System (Fig. 29).
Fig. 25—Mounting S321A Touchpad in a 3-gang
junction box.
M3504A
6 WIRE
CABLE
3-GANG JUNCTION
BOX IN DRYWALL
Fig. 26—Wiring the S321A Touchpad to the
W180A Controller.
M8168
18-22 AWG WIRE SHIELDED,
SOLID OR STRANDED,
THREE TWISTED
PAIRS AS SHOWN
YELLOW
YELLOW
YELLOW
GREEN
GREEN
GREEN
RED
RED
BLACK
BLACK
S321
TOUCHPAD
WIRE NUTS
(TYPICAL)
TO TOUCHPADS
+
–
+
–
+
–
+
–
DATA
END
12 VDC
12 VDC
external
int.
W180 TERMINATION PANEL
g. Mount the Touchpad in the junction box in the
four inside mounting holes, using the screws
supplied.
h. Position the trim ring on the Touchpad (note the
UP reference on the rear surface of the trim ring)
and snap it onto the Touchpad.