Honeywell UDC3200 series, Руководство по эксплуатации продукта

Страница: 93 / 243

Configuration
Function Prompt Selections or
Parameter
Lower Display Range of Setting
Upper Display
Definition
TO HOLD TO HOLD —Contact closure suspends Setpoint
Program or Setpoint Ramp. When contact reopens,
the controller starts from the Hold point of the
Ramp/Program unless the Ramp/Program was not
previously started via the
Run
Hold
Run
Hold
Run
Hold
key.
This selection applies to either loop.
TO PID2 TO PID2 —Contact closure selects PID Set 2.
PV 2IN
PV=INPUT 2 —Contact closure selects PV = Input 2.
RERUN RERUN-- Allows the Setpoint Programmer to be
reset to the initial segment of its current cycle, unit
stays in previous mode.
TO RUN
RUN —Contact closure starts a stopped SP Ramp or
Program. Upper left character blinks “R”. Reopening
the contact puts controller in HOLD mode.
This selection applies to either loop.
ToBEGIN EXTERNAL SP PROGRAM RESET —Contact
closure resets SP Program back to the beginning of
the first segment in the program and places the
program in the HOLD mode. Program cycle number
is not affected. Reopening switch has no effect.
This selection applies to either loop.
ATTENTION Once the last segment of the setpoint
program has timed out, the controller enters the
mode of action specified in the configuration data
and the program cannot be reset to the beginning of
the first segment by digital input closure.
STOP I
INHIBIT INTEGRAL (RESET) —Contact closure
disables PID Integral (Reset) action.
MAN FS
MANUAL FAILSAFE OUTPUT —Controller goes to
Manual mode, output goes to the Failsafe value.
ATTENTION This will cause a bump in the output
when switching from Automatic to Manual. The
switch back from Manual to Automatic is bumpless.
When the switch is closed, the output can be
adjusted from the keyboard.
TO LOCK KEYBOARD LOCKOUT —Contact closure disables
all keys. Lower display shows LOCKED if a key is
pressed.
12/04 UDC3200 Universal Digital Controller Product Manual 81