Honeywell UDC3200 series, Руководство по эксплуатации продукта

Страница: 74 / 243

Configuration
Function Prompt Selections or
Parameter
Lower Display Range of Setting
Upper Display
Definition
If a 2 % Deadband is desired, then enter 2.0 for the
Deadband selection in the Control Algorithm group.
This will apply Deadband to the Current Output. In
the Options group, set the Auxiliary Output LOW
VAL selection to
49.0 and the HIGH VAL selection to
0.0 .
100PCT
CURRENT DUPLEX RANGE (FULL) enables the
Current Output to provide both heat and cool
functions for control over 0-100 % of the controller
output. The PID heat parameters apply when the
output is greater than 50 % and the PID cool
parameters apply when the output is less than 50 %.
The second current output is not required for this
type of duplex operation.
RLYSTATE
1OF 2OF
1ON 2OF
1OF 2ON
1ON 2ON
DIGITAL OUTPUT STATUS AT 0 % OUTPUT
allows the following selections:
1OF 2OF Output 1 de-energized
Output 2 de-energized
1ON 2OF Output 1 energized
Output 2 de-energized
1OF 2ON Output 1 de-energized
Output 2 energized
1ON 2ON Output 1 energized
Output 2 energized
RLY TYPE RELAY CYCLE TIME INCREMENT selection is
used only for Time Simplex and Duplex output
configurations. This configuration sets the increment
size of the relay cycle times in the Tuning and
Tuning 2
Set Up groups.
MECHAN ELECTROMECHANICAL RELAY —Cycle time in
one-second increments.
SOL ST SOLID STATE RELAY —Cycle time in 1/3 second
increments. This is useful for solid state relay
applications that require shorter cycle times. DO
NOT use this setting unless cycle times of less than
1 second are required.
ATTENTION The Lockout selection must be set to
NONE in order to view this selection.
MOTOR TI 5 to 1800 seconds MOTOR TIME – Appears only when “POSITON” is
selected as the Output algorithm. This is the time it
takes the motor to travel from 0 to 100% (fully closed
to fully open). This time can usually be found on the
nameplate of the motor.
62 UDC3200 Universal Digital Controller Product Manual 12/04