10. Replace both the left and right front retaining brackets. Position the stop peg covered with Vinyl cap
such that it is in contact with the front bezel on the left side and the front bezel handle on the right
side. Tighten the hex threaded standoff to lock each stop peg in place.
11. If you are installing a second workstation in the console, repeat the above steps for the second
workstation, then go to section,
Connect cables to the workstation
If you are not installing a second workstation and if an air duct baffle and blank front panel is not
already installed continue to the next step.
12. Install a 4U high air duct baffle against the console right mounting rail.
13. Attach the blank front panel to the console rails using two hex head screws and two washers,
making sure the flat side of the washer touches the screw head and the washer teeth touch the
panel.
- 39 -
Chapter 3 - Installing
