Honeywell NOTIFIER AM-8200, Руководство по установке, Страница: 20 / 46

AM-8200 Installation Manual PAGE - 17
AM8200_manu-inst Doc. M-162.2-AM8200-ENG Rev A.2 NOTIFIER ITALIA
DIP SWITCH SW401 on CPU Board
Dip switch Note
1 2 3 4
OFF OFF OFF OFF Normal Operating setting
ON OFF OFF OFF Copy the configuration in the USB memory key
OFF OFF OFF ON Firmware updating
ON OFF OFF ON Restore factory configuration
ON ON ON ON from USB memory key loads configuration previously prepared by PK-8200 SW Tool
AM-82-MB Terminal Board
CN1 terminal
N° description Function Note
L Phase
230Vac mains Power
Fused with 2 AL
Ground
N Neutral
CNU terminal block
N° Description Characteristics Note
20
Fault relay N.C./ N.O. Max 30V 2A Select N.O./N.C. with JGST Jumper
or supervised output (resettable fuse
0.3A) with EOL resistor 47KΩ
19 Fault relay “Common”
18 Sounder (Negative in non alarm) 1 A resettable fuse (this is a
polarity inversion output). EOL resistor = 47KΩ
17 Sounder (positive in non alarm)
16 User 2 Relay N.C./ N.O.
Max 30V 2A Select N.O./N.C. with JUSR2 Jumper
or supervised output (resettable fuse
0.3A) with EOL resistor 47KΩ
15 User 2 Relay “Common”
14 User 1 Relay N.C./ N.O.
Max 30V 2A Select N.O./N.C. with JUSR1 Jumper
or supervised output (resettable fuse
0.3A) with EOL resistor 47KΩ
13 User 1 Relay “Common”
12 Alarm Relay N.C./N.O.
Max 30V 2A Select N.O./N.C. with JALL Jumper
or supervised output (resettable fuse
0.3A) with EOL resistor 47KΩ 11 Alarm Relay “Common”
10 GND USR 2 A resettable fuse
9 +24V USR
8 Line 2 B-
Detection LINE 2
7 Line 2 B+
6 Line 2 A-
5 Line 2 A+
4 Line 1 B-
Detection LINE 1
3 Line 1 B+
2 Line 1 A-
1 Line 1 A+
JUSR2
Flat cable for interconnection with LIB-8200
User terminal block
Connector for optional board
Flat cable for interconnections
with AM8200-KLCD
Flat cable for interconnection with AM-82-BBMB
JGST
JALL
JUSR1