Honeywell HS-600, Описание и руководство по установке

Страница: 66 / 107

SYSTEM DESCRIPTION AND INSTALLATION MANUAL
HS--600 High Speed Data System
23--20--31
30 May 2002
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
Page 4--2
C. Power Checks
(1) Check the pins listed in Table 4-1.
Table 4-1. Power Checks
LRU Connector Pin Signal
HS--600 HSU BP1 115 V ac (High)
BP7 115 V ac (Low)
BP2 28 V dc (High)
BP3 28 V dc (Low)
HSD System HPA (Note) BP1 115 V ac (High)
BP7 115 V ac (Low)
NOTE: The HPA is also available as 28V dc. See Honeywell Pub. No. C15--5111--005 for installation details.
D. RF Checks
(1) Check the pins listed in Table 4-2. Figure 4-1 shows the receive (RX) path loss and
Figure 4-2 shows the transmit (TX) path loss. These losses are achieved by a
combination of RF coaxial cable losses and installed RF attenuators (the latter, if
required).
Table 4-2. RF Checks
From LRU Connector Pin To LRU Connector Pin
RX Splitter RX IN DLNA J2 (RX OUT)
RX OUT MCS--3000 SDU or
MCS--4000 SDU or
MCS--7000 SDU
BP13 (RX IN)
RX OUT MCS--6000 RFU TP1C (RX IN)
RX OUT RF Attenuator IN
RF Attenuator OUT HS--600 HSU BP12 (RX IN)
Combiner TX OUT DLNA J1 (TX IN)
TX IN HSD System HPA MP1C (RX OUT)
TX IN SATCOM System HPA MP1C (RX OUT)
HS--600 HSU BP13 (TX OUT) RF Attenuator IN
RF Attenuator OUT HSD System HPA TP1C (RF IN)