SYSTEM DESCRIPTION AND INSTALLATION MANUAL
HS--600 High Speed Data System
23--20--31
30 May 2002
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
Page 5--6
E. Maintenance Menu Items
(1) The maintenance menu items given in Table 5-4 can be accessed through the
maintenance port by pressing the ENTER key after the HS--600 system has booted
up. (See paragraph 2.D. in this section.)
NOTE:
Items listed in Table 5-4 are for reference only and will be set by the
manufacturer.
NOTE:
Changes to the parameters listed in Table 5-4 should only be accomplished
by qualified personnel or after consulting your Honeywell representative.
Table 5-4. Maintenance Menu Items
IIIIIIIIIIIIIIII Maintenance Parameters Setting IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII¯
§
§
§ 1. P(tx) Initial EIRP: 25.0dBW
§
§ 2. Ref. oscillator correction factor: --125Hz
§
§ 3. Transmit Doppler compensation adjustment rate: 60Hz/sec
§
§ 4. G(M--H) ISE MTU--to--HPA output gain: 40dB
§
§ 5. HPA output to antenna input loss: 2dB
§
§ 6. G(Amin) Minimum usable reported antenna gain: 7dB
§
§ 7. P(omin) Max. allowed HPA average output power: 17.0dBW §
§ 8. Enabled BEARE Service Interface: 0
§
§ 9. Min. Frame No. for TX port: 3
§
§ A. HPA Format Selection: N
§
§ S. Save setting and Exit
§
§
§
EIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
Enter your selection: 1
P(tx) Initial EIRP, range 20 to 25dBW in 0.5dBW steps: 25.0Hz
Please enter new value between 20.0 to 25.0):
Keep current value!
Enter your selection: 2
Reference oscillator correction factor
range +/--2200Hz, in 1Hz step: --125Hz
Please enter new value between --2200 to 2200(+/--XXXX):
Keep current value!
Enter your selection: 3
Transmit Doppler compensation adjustment rate, default is 60Hz/sec.
Please make your choice :
1. 30Hz/sec.
2. 60Hz/sec.
Enter your choice:
Use default Transmit Doppler compensation adjustment rate, 60Hz/sec.
Содержание HS-600
