Honeywell ADEMCO Vista-12C, Инструкция по установке и настройке

Страница: 40 / 112

Installation and Setup Guide
4-4
FIELD TITLE and DATA ENTRIES EXPLANATION
*36
Entry Delay 2
See *35 above for entries.
See *35 for explanation.
*37
Audible Exit Warning
0 = no; 1 = yes
Warning sound consists of slow continuous beeps until
last 10 seconds, then it changes to fast beeps. Sound
ends when exit time expires.
*38
Confirmation Of Arming Ding
Entry 1: 0 = no; 1 = yes, 1-second ding
(ding if armed from wired keypad)
Entry 2: Enter 0-15 from table below.
(ding if armed from RF device)
Entry Ding at Siren Trigger 2 Output
0 none none
1 none 250mS
2 none 1 second
3 none 4 seconds
4 250mS none
5 250mS 250mS
6 250mS 1 second
7 250mS 4 seconds
8 1 second none
9 1 second 250mS
#+10 1 second 1 second
#+11 1 second 4 seconds
#+12 4 seconds none
#+13 4 seconds 250mS
#+14 4 seconds 1 second
#+15 4 seconds 4 seconds
Entry 1 for each partition selects whether arming
from wired keypads causes siren ding. Confirmation of
arming is 1/2 second external sounder “ding.” Ding
occurs when closing reports is sent, or when exit delay
expires.
Entry 2 for each partition selects whether arming from
remote RF devices causes siren ding and/or activates
trigger 2 output; also selects siren ding/trigger
activation duration (arm = 2 dings of selected duration
with 1 second off between; disarm = 1 ding of selected
duration). Ding occurs upon reception of the wireless
arming command.
NOTE: If using an option that activates trigger 2,
trigger 2 must be dedicated to only this function; do
not assign any other functions to trigger 2.
*39
Power-Up In Previous State
0 = always power-up in a disarmed state
1 = assume the system status prior to
power down
When the system powers up armed, an alarm will
occur 1 minute after arming if a zone is faulted at that
time.
Note that if the previous state was armed AWAY or
STAY, the system will not respond to sensor changes
for 1 minute, which allows time for sensors such as
PIRs to stabilize.
Dialer Programming (
∗∗∗∗
40 –
∗∗∗∗
50)
FIELD TITLE and DATA ENTRIES EXPLANATION
*40
PABX Access Code
Enter up to 6 digits if PABX is needed to
access an outside line. Do not fill unused
spaces.
0–9, # + 11 for ‘
∗
’, # + 12 for ‘#’, # + 13 for a
pause (2 seconds)
To clear entries from field, press
∗
40
∗
. If fewer than 6
digits need to be entered, exit by pressing [
∗
], which
advances to the next field.
Call Waiting: If the subscriber’s phone service has
“call waiting” (and is not using PABX), enter “*70” (“#
+ 11”) plus “# + 13” (pause) as the PABX entry to
disable “call waiting” during control panel calls. If the
subscriber does not have “call waiting” and is not using
PABX, make no entry in this field.