Honeywell 11 kW, Руководство пользователя

Страница: 25 / 96

Section 4: Maintenance
Owner’s Manual for 60 Hz Air-cooled Generators 21
2.
Inspect the battery posts and cables for tightness
and corrosion. Tighten and clean as necessary.
3.
Check the battery fluid level of unsealed batteries,
and if necessary, fill with distilled water only. DO
NOT use tap water. Also, have the Independent
Authorized Service Dealer or a qualified Service
Technician check the state of charge and condition.
Strictly observe the following precautions when working
on batteries:
•
Remove the 7.5 Amp fuse from the generator
control panel.
•
Remove all jewelry—watches, rings, metal objects,
etc.
•
Use tools with insulated handles.
•
Wear rubber gloves and boots.
•
Do not lay tools or metallic objects on top of the
battery.
•
Disconnect the charging source prior to connecting
or disconnecting battery terminals.
•
Wear full eye protection and protective clothing.
•
Where electrolyte contacts the skin, wash it off
immediately with water.
•
Where electrolyte contacts the eyes, flush
thoroughly and immediately with water and seek
medical attention.
• Wash down spilled electrolyte with an aid
neutralizing agent. A common practice is to use a
solution of 500 grams (1 pound) bicarbonate of
soda to 4 liters (1 gallon) of water. The bicarbonate
of soda solution is to be added until the evidence of
reaction (foaming) has ceased. The resulting liquid
is to be flushed with water and the area dried.
• DO NOT smoke when near the battery.
• DO NOT cause flame or spark in the battery area.
• Discharge static electricity from the body before
touching the battery by first touching a grounded
metal surface.
Attention After Submersion
If the generator has been submerged in water, it MUST
NOT be started and operated. Following any submersion
in water, have an Independent Authorized Service Dealer
thoroughly clean, dry, and inspect the generator. If the
structure (home) has been flooded, it should be
inspected by a certified electrician to ensure there won’t
be any electrical problems during generator operation or
when utility power is returned.
Corrosion Protection
Regular scheduled maintenance should be conducted to
perform a visual inspection of the unit for corrosion.
Inspect all metal components of the generator. Example:
Base frame, enclosure, brackets, alternator can, the
entire fuel system (inside and outside of the generator)
and fastener locations. If there is corrosion found on
generator components (i.e. regulator, engine/alternator
mounts, fuel plenum, etc.), replace parts as necessary.
Periodically wash and wax the enclosure using
automotive type products. Do not spray the unit with a
hose or power washer. Use warm, soapy water and a soft
cloth.Frequent washing is recommended in salt water/
coastal areas. Spray engine linkages with a light oil such
as WD-40.
Remove From, and Return To
Service Procedure
Remove From Service
If the generator cannot be exercised every 7 days and
will be out of service longer than 90 days, prepare the
generator for storage:
1.
Start the engine and let it warm up.
2.
Close the fuel shutoff valve in the fuel supply line
and allow the unit to shut down.
3.
Once the unit has shut down, set the generator
main circuit breaker (Generator Disconnect) to
OFF (OPEN).
(000162)
WARNING
Explosion. Do not dispose of batteries in a fire.
Batteries are explosive. Electrolyte solution can cause
burns and blindness. If electrolyte contacts skin or eyes,
flush with water and seek immediate medical attention.
(000137a)
WARNING
(000164)
WARNING
Electrical shock. Disconnect battery ground
terminal before working on battery or battery
wires. Failure to do so could result in death
or serious injury.
(000138a)
WARNING