Honda TRX400EX FOURTRAX 1999, Руководство по обслуживанию

Страница: 72 / 263

FUEL SYSTEM
FLOAT
AND
JETS
NEEDLEJET
Install the pilot screw with the spring, washer and a
new O-ring and return
it to its original position as
noted during removal.
Perform the pilot screw adjustment i f new pilot screw
is
installed.
CAUTION:
Damage t o the pilot screw seat
will
occur
if
the pilot
screw
is
tightened against the seat
Install the needle jet, needle jet holder and tighten
the lock nut. Install the main jet and slow jet.
CAUTION:
Handle the
with
care. They can easily be scored
or scratched.
'00 Hang the float valve onto the float arm lip.
Install the float valve, float and
float pin.
Install the float pin by gently tapping with a suitable pin
driver
2
as shown.
0.5 0.3 m m
0.01
in)
FROM AIR CLEANER
HOUSING
FLOAT LEVEL INSPECTION
NOTE:
Check the float level after checking the float valve,
valve seat and float.
Set the float level gauge so that it is perpendicular
to the float chamber face at the highest point of
the float.
With the float valve seated and the float arm just
touching the valve, measure the float level with the
float level gauge.
TOOL
Carburetor float level gauge
FLOAT LEVEL 18.5 mm (0.73 in)
The float cannot be adjusted.
Replace the float assembly if the float level
is out of
specification.
Install the diaphragm shaft boot of the accelerator
pump until it is flush with the carburetor body.
Install the baffle plate by aligning its groove with the
lug on the carburetor body as shown.
BAFFLE PLATE
07401
-
0010000
5-8