Honda FG110, Руководство пользователя

Страница: 78 / 81

Date of Issue: February, 2005
© American Honda Motor Co., Inc.
11-3
FG110
3. REASSEMBLY
1. Press each tine shaft bearing into the transmission case
until it seats against the ledge in the case.
2. Reassemble the driveshaft components as shown.
3. Hold the worm shaft by hand and hand tighten the outer
clutch.
4. Install the assembled driveshaft into the transmission
case. Be sure the notch on the driveshaft bushing fits into
the slot in the transmission case.
5. Remove the old sealant from both halves of the
transmission case.
6. Clean the mating halves of the transmission case using a
degreasing agent and a clean shop towel.
7. Apply a thin bead of liquid gasket (Hondabond 4, Three
Bond 1207 or equivalent) to the transmission case.
8. Install the tine shaft into the transmission case halves.
9. Assemble the two halves of the transmission and tighten
the eleven 6 x 23 mm flange bolts.
10.If the grass guards were removed, reinstall them over the
tine shaft.
11. Lubricate the assembled transmission (P. 3-10) .
OUTER CLUTCH
RADIAL BALL BEARING
RADIAL BALL BEARING
WORM SHAFT
WASHER
DRIVESHAFT BUSHING
NOTCH
REASSEMBLY:
Fit into the slot in the
transmission case.