Honda FG110, Руководство пользователя

Страница: 8 / 81

FG110
Date of Issue: February, 2005
© American Honda Motor Co., Inc.
2-1
2. SERVICE INFORMATION
1. SERVICE RULES
• Use genuine Honda parts or their exact equivalent. Lower quality parts can damage the tiller or reduce its
performance.
• Install new gaskets, O-rings, and seals during reassembly.
• This tiller uses metric fasteners and SAE (non-metric) fasteners. Metric bolts, nuts, and screws are not
interchangeable with non-metric fasteners. The use of incorrect tools and fasteners may damage the tiller.
• When tightening nuts and bolts, begin with the larger-diameter or inner bolts, and tighten diagonally to the specified
torque values, unless a particular tightening sequence is specified.
• When tightening self-tapping screws, be especially careful to avoid cross-threading or overtightening.
• Clean parts in nonflammable solvent after disassembly.
• Lubricate sliding surfaces before reassembly.
• After reassembly, check parts installation and operation.
2. SYMBOLS USED IN THIS MANUAL
As you read this manual, you may find the following symbols with the instructions.
1. SERVICE RULES . . . . . . . . . . . . . . . . . . . . . . . . 2-1 5. TORQUE VALUES . . . . . . . . . . . . . . . . . . . . . . . 2-4
2. SYMBOLS USED IN THIS MANUAL . . . . . . . . . 2-1 6. TOOLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-5
3. SERIAL NUMBER LOCATIONS . . . . . . . . . . . . 2-2 7. ENGINE TROUBLESHOOTING . . . . . . . . . . . . . 2-6
4. SERVICE SPECIFICATIONS . . . . . . . . . . . . . . . 2-3

A special tool is required to perform the procedure.
(commercially
available)
Commercially available tools are distinguished by the words (commercially available). They
are not available through the American Honda Parts Department. Most commercially available
tools shown in this shop manual can be ordered through the Tool and Equipment program by
calling (888) 424-6857. Refer to the Tool and Equipment program catalogue for a complete
tool listing.

Apply grease

Apply oil
O x O (O) Indicates the diameter, length, and quantity of metric flange bolts used.
P. O-O
Indicates the reference page. When viewing on-screen, click the reference to go to the
referenced page.