Honda FG110, Руководство пользователя

Страница: 29 / 81

Date of Issue: February, 2005
3-10
© American Honda Motor Co., Inc.
FG110
12. TRANSMISSION LUBRICATION
1. Place the tiller on the left side as shown.
2. Remove the lock pin from the right side tine shaft by
turning it up [a] and pulling it out [b] as shown.
3. Wear heavy gloves and remove both right side tines. If the
tines are difficult to remove, rinse the tine shaft with water
and detergent to remove dirt from between the tines and
shaft. Do not use a hammer to remove the tines, or you
might distort the tine hub and make it difficult to remove the
tines.
4. Remove the air vent screw and fill hole screw from the
transmission case.
5. Fill the transmission by using a grease gun or grease
applicator at the fill hole screw opening. Push the gun or
applicator against the opening so as to seal the nozzle of
the gun or applicator against the casting embossment.
Apply grease until grease begins to come out of the top air
vent hole.
6. Reinstall the air vent screw and fill hole screw.
7. Clean the tine shaft and place a few drops of oil on the tine
shaft before installing the tines.
8. Wear heavy gloves and reinstall the tines in the reverse
order of removal.
9. Install the lock pin through the round side of the tine shaft
hole, then turn it over to lock it in place.
Grease NLGI #2 general purpose
(b)
(a)
FILL HOLE
SCREW
OPENING AIR VENT
SCREW
OPENING
LOCK PIN
RIGHT OUTER
TINE (D)
RIGHT INNER
TINE (C)
GREASE GUN