Honda FG110, Руководство пользователя

Страница: 69 / 81

Date of Issue: February, 2005
9-14
© American Honda Motor Co., Inc.
FG110
6. Loosen the push rod [1] and tighten the holder bolt [2] by hand
until the valve lifter [3] contacts the cylinder head cover mounting
boss [4]. Be sure that the bolt (5 mm) [5] is in the center of the
long hole in the special tool.
NOTICE
The cylinder head cover mounting boss can be damaged by
tighten the push rod with the bolt (5 mm) not in the center but on
either side in the long hole. Be sure that the bolt is in the center of
the long hole securely.
7. Using a 14 mm wrench, retighten the push rod [1] until the
adapter [2] comes to the shaft of the valve lifter [3]. Loosen the
push rod and remove the bolt (5 mm) [4], and then remove the
special tool.
8. Measure the clearance between the rocker arm and the cylinder
head, and make sure if the clearance are within the specification.
If the clearance is over the specification, the rocker arm is not
correctly installed to the valve lifter. Install the special tool again,
and tighten the push rod until the rocker arm is completely
pressed onto the shaft of the valve lifter.
9. Inject the oil as shown. Lift the lifter by finger and release the lifter,
and make sure it operates by the lifter’s weight.
Install the adjusting screws and the adjusting screw lock nuts to
the rocker arms.
Install the cam pulley (P. 8-2) .
Adjust the valve clearance (P. 3-7) .
Rocker arm and cylinder head clearance:
0.15 – 0.65 mm (0.006 – 0.026 in)
[1]
[4]
Loosen Tighten
[2]
[5]
[3]
[1]
[4]
[3]
[2]
Tighten
0.15 mm - 0.65 mm (0.006 - 0.026 in)
Revised: March, 2015
© American Honda Motor Co., Inc.