Holiday Trip 2012, Руководство пользователя

Страница: 99 / 242

9
E
qu
ip
m
en
t
-
5
2012 Trip
eqUIpment - IntroDUctIon
This section covers the basic operation and
care of equipment. More detailed information
about specific equipment may be found in that
particular OEM manual. Optional equipment
will also be discussed in this section that may
not apply to all motorhomes.
INFORMATION:
Detailed information with CAUTION
or WARNING instructions for the
various electronics, other than what is
provided in this section, can be found
in their specific OEM manual.
entry Step
Operation
The exterior electric entry step will extend
and retract with door opening and closing,
automatic retraction with the ignition key in
the run position and a “last out” feature. The
entry switch illuminates when turned on.
NOTE:
When dry camping, it is important
to note that when the switch is
illuminated all step circuits are active
and drawing current from the chassis
battery.
NOTE:
The chassis battery disconnect switch
must be on for the entry step to
operate.
Entry Step Operation:
With entry step switch on, the step will
extend and retract when the entry door opens
and closes.
Cancel Step Operation When Parked:
Open door to extend step. Turn the entry
step switch off. The entry step will remain
extended.
Last Out Feature:
Turn the ignition off and open the door. The
step will extend. This is the “last out” feature.
Ignition Override:
When the ignition is on, the step will extend
and retract with door movement with the entry
step switch off. This ensures the step will not
be extended during travel and will extend
when the door is opened.
WARNING:
The entry step will retract when the
ignition switch is turned on. Always
confirm the entry step is fully extended
and locked in position prior to exiting
the motorhome.
CAUTION:
High curbs can impede step operation.
Use care when parked on side streets.
If the entry step fails to operate:
Verify that the entry step switch is on.
Check the main power supply for the
step: a 25 Amp fuse located in the
roadside front electrical panel.
A magnetic door jam switch is used to
control step operation. Use a separate
magnet to apply a “trigger” to the door
jam switch. Rotate test magnet to align
polarity field.
WARNING:
If the motorhome is driven with the
step in the extended position, damage
could occur to both the step and the
motorhome.
CAUTION:
Keep fingers, clothing and other
hardware away from moving
components.
Maintenance
The steps are equipped with self-lubricating
bushings in the drive assembly and step joints
and require no maintenance. If in extreme
weather conditions and lubrication is deemed
necessary a silicon based grease or spray can
be used on the bushings.
INSPECTION:
Clean and inspect step more frequently
in adverse weather conditions. Mud,
snow, road salts and sand could
quickly break down lubricant and
corrode painted surfaces.



060370a
Located next to entry door.
Entry step switch
020325