120
W
at
er
S
ys
te
m
s
-
6
2012 Trip
Set City Water/Fresh Tank Fill handle
to the City Water position.
Turn on the water.
The water pump can either be off or
on. It will not affect the water pump to
leave it on.
Slowly open each faucet, one at a time,
to purge trapped air.
Water pUmp
The water pump pressurizes the fresh water
system when the system is not connected to
city water. The water pump is self-priming,
operating on demand as water is used. The
water pump is located in the water service
center.
To Operate the Water Pump:
Ensure the house battery disconnect
switch is on.
Battery cut-off switch must be on.
WARNING:
Before leaving the motorhome for
extended periods of time (i.e. overnight
or longer) the city water source and
water pump must be turned off. The
manufacturer is not responsible for
damage caused from neglect.
The water pump can be operated from
these locations:
Systems Panel.
Water Service Center.
To turn the water pump
On or Off:
Press the water pump
switch. The indicator lamp
illuminates when the water
pump is turned on.
WARNING:
Do not continue water
pump operation if the fresh water
holding tank is empty. Damage to the
water pump or electrical supply system
may result.
To operate the water pump after
unhooking from a city water source or
after storage:
Close all drain valves and low point
drains.
Fill the fresh water tank.
Open the hot and cold water valves of
each faucet.
Turn the water pump on. Wait for the
water lines and the hot water tank to
fill.
Close each faucet when it delivers a
steady stream of water (cold water
faucets first).
Water Pump Troubleshooting
Water pump will not start or blows the
fuse:
Check the electrical connections, fuse
or breaker, main switch and ground
connection.
Is voltage present at the pressure
switch on the pump? If voltage is
present, the pressure switch may be
faulty. As a test, temporarily bypass the
pressure switch.
Check the charging system for correct
voltage and good ground.
Check for an open or grounded circuit
or motor.
Check for a seized or locked
diaphragm assembly (water frozen).
Water pump will not
prime or sputters (No
discharge/motor runs):
Check the pump inlet
strainer for clogs and
debris.
Check the tank for water
or air collected in the
water heater.
Check the inlet tubing
and plumbing to see if
it is sucking in air at
plumbing connections
(vacuum leak).
Check for proper voltage with the
pump operating.
Check the pump housing for cracks or
loose drive assembly screws.
Water pump inlet
screen:
Clean
every two months.
040586
040537c
Service center
water pump switch
Содержание Trip 2012
