8
A
pp
lia
nc
es
-
4
2012 Trip
Air Conditioner Operation
Setting the thermostat to control air
conditioner functions:
Slide switch to Cool.
Press the Zone button repeatedly to
select desired zone.
Press the Mode button repeatedly until
Cool is displayed.
Set desired fan speed by pressing the
Mode button repeatedly. Fan speed
Auto (default setting in Cool mode)
will vary fan speed dependant on
disparity of temperature set point and
actual zone temperature. If desired, fan
speed can be set to Cool Fan High or
Cool Fan Low.
Set desired temperature by pressing the
Up or Down buttons.
Repeat process for each desired zone.
NOTE:
The compressor will engage
approximately two minutes after
blower motor activation to prevent
accidental compressor operation
against high pressure.
Heat Pump Operation
In Heat Pump mode the air conditioning
principle is reversed, supplying heated air to
the ceiling registers instead of refrigerated air.
There are ambient temperature limitations in
Heat Pump mode.
Slide switch to Heat.
Press the Zone button repeatedly to
select desired zone.
Press the Mode button repeatedly until
Heat and Elec is displayed.
Set desired temperature by pressing the
Up or Down buttons.
Repeat process for each desired zone.
NOTE:
Fan speed is not adjustable in heat
pump mode.
NOTE:
The roof air conditioner will not
operate in heat pump mode in cold
ambient temperature (approximately
46° F.). If zone temperature and
temperature set point is greater than
5º, the furnace will be used as the
primary heat source until temperature
disparity is less than 5º.
NOTE:
The propane must be on for the
backup heat source (furnace) to
function.
Air Conditioner Maintenance
Return Air Filters:
Frequently clean the return air filters. The
filters are located behind the return air vent
cover.
To Lower Vent Covers:
Use a suitable driver or coin to unscrew
vent intake cover fastener.
Remove cover and filter.
To Clean the Return Air Filters:
Wash filters in warm soapy water.
Do
not
use solvents.
Rinse filters thoroughly with fresh
water. Allow them to dry.
Install filters and secure intake vent
covers.
Filter Removal
031357a
Example of A/C screen
031359a
Example of
heat pump screen
031359a
Example of heat pump screen
in backup furnace mode.
031359a
Содержание Trip 2012
