Step 23: Washout Assm.
Parts List
Washout Assembly (1)
Washout Anti-Rotation Guide (1)
2.0mm Med Ball Links (2)
Install the Washout on the main shaft
and finish by connecting the washout
links to the swashplate. After the
Washout is in place install the
Washout Anti-rotation Guide over
the Main Shaft with the pin placed into
the slot on the washout unit. Keep the
guide loose until the Head and control
linkages are installed.
Step 24: Main Rotor Head Assm. & Installation
Parts List
Main Rotor Head (1)
Flybar (1)
Flybar Control Arms (2)
3mm Spacers (2)
Flybar Control Paddles (2)
Before you bolt the head to the main
shaft, install the 3mm
fly bar and paddles. First step is to
insert the fly bar into the seesaw
unit and position so that it is close
to center. Next slide the 3mm shim
over the fly bar followed by the
fly bar control arms. This will need
to be done on each side of the
seasaw unit. To ensure that the
fly bar is centered, measure the
remaining length on each side of the
seesaw and make them the same.
After the fly bar is centered, tighten
the 3mm set screws onto the fly bar
making sure the arms are parallel.
After the fly bar is secured into the
head, make a mark on each side of the
fly bar 20mm in from the end. Then
screw the paddles on to this mark
make sure they are parallel to the
fly bar control arms. The two holes
in the fly bar paddles are for general
flying andacrobatic flying. The front
hole gives slower rates, the back faster.
Attach the Head to the main shaft using a
3mm X 22mm Cap Head Bolt &
3mm Lock Nut.
3mm Set Screws (2)
3 X 22mm Cap Head Bolts
3mm Lock Nuts
