Step 7: Installation of Clutch Lining
Parts List
Clutch Bell (1)
Clutch Lining (1)
Install the clutch lining into the
clutch bell. Scuff up the inside of
the clutch bell with Xacto knife for
better glue adhesion. Use two-part
JB Weld (8265S). The clutch
lining is pre-cut, but for future
reference the length is 126mm.
Perform a dry fit, but make sure
the lining is completely secure
against the inside walls of the
clutch bell. Remove lining. Now
apply a thin layer of JB weld to
clutch bell. Insert clutch lining
making sure the ends butt up to
each other properly and
smoothly. Lack of trueness or
excessive use of JB weld will
cause improper engagement of
the clutch shoe
.
Step 8: Installation of Clutch Bell
Parts List
Start Shaft (1)
Start Coupler (1)
Clutch Bell (1)
4 x 4mm Set Screw (1)
Insert the Start shaft through the center of the
clutch bell. Take the clutch bell and the start
shaft and insert assembly into the clutch bell
bearing-block. Mesh both gears and be sure that
the clutch bell is firmly in place. Slide the
start- coupler onto the start-shaft where it comes
through the bearing block on the top side.
Tighten the set-screw onto the flat on shaft
making sure that shaft does not have any
up or down play. Adjust if necessary.
