Step 12: Installation of Clutch
Parts List
Clutch (1)
3 X 8mm Cap Head Bolts (2)
The final step before engine installation
is to attach the clutch to the fan hub.
You may check for run-out by
dial-indicating the bearing surface
between the one-way bearing and the
clutch. Use the 3 X8 mm Cap Head
Bolts to attach the clutch to the fan
Hub.
Step 13: Installation of Motor into Helicopter
Parts List
3 X 8mm Cap Head Bolts (4)
Install the motor into the frames using 3 X 8 mm Cap head bolts. At this point you will want to finalize
the gear mesh making sure that the engine and clutch are straight and the all gears move smoothly.
Also making sure that the clutch is fully housed in the clutch bell. Make sure that all gears are fully engaged
into each other but do not over engage the gears because you want the gears to run smooth.
Step 14: Installation of Right Angle Frame Rails
Parts List
Right Angle Frame Rails (1)
54mm Cross-member (1)
Install lower frame rails. Be careful to examine
and determine the left rail from the right
rail - they are different! The rear-most hole
uses a 3 X 8mm cap head bolt threaded into
a 54mm cross member. Next, the front hole
is attached to the frame support using a
3 x 8 mm Cap Head Bolt. The remaining
four holes use 3 X 8mm cap head bolts
retained with 3mm lock Nuts.
3 X 8mm Cap Head Bolts (8)
3mm Lock Nuts (4)
