Step 5: Installation of Front Tail Pulley
Parts List
Tail Pulley (1)
3mm Set Screw (1)
The Front Tail Pulley is installed over the reduced
portion of the Counter Gear Shaft. Tighten the
Set screw into the pulley be sure that it is secured
to the flat on the shaft.
The Counter Gear Shaft
pictured on the left illustrates
the reduced portion of the
shaft. make sure the pulley
is fastened to the flat shown
in this picture.
Step 6: Installation of Main Gear Assm. & Main Shaft
Parts List
Main Shaft Retainer Collar (1)
MainShaft (1)
Main Gear & Autorotation Clutch Assm. (1)
3 X 16mm Cap Head Bolt (1)
3mm Lock Nut (1)
3mm Washers (2)
3mm Set Screws (4)
This is the installation of the main
shaft and main gear. All you have
to do is slide the main gear into the
opening in front of the front tail
pulley assembly. Once the main
gear is installed you need to slide
the main shaft through the main
shaft bearing blocks from the top
down. Once the main shaft is in
place put the 3 X 16mm cap head
bolt with a washer through the hole
in the bottom of the autorotation
clutch. Put a washer on the other
end of the bolt and lock it down
with the 3mm locknut. Now your
autorotation clutch should be
attached to the mainshaft. Next is
to install the main shaft retainer collar. All you have to do on this
is to slide the collar over the main shaft, pull the mainshaft up so that
there is no slop, and install the four 3mm set screws.
