HKC SW-1070, Руководство по установке, Страница: 53 / 122

SW-1070 Panel / Output Card
Default Eng. Code - 4567 Default User Code - 1111 (Irl) 1234 (UK)
53
NOTE:
Please ensure that
zone terminals are
linked as shown.
NOTE:
There are two
types of Output
Card - one with
relays and one
with open
collectors
NOTE:
Each relay can be energised or
de-energised by pressing its
adjacent switch.
NOTE: Max. cable run to Output Card = 200m
A total of 600m of cable can be used.
Position OC51
Position OC61
You can convert some of your hardwired zones (zones 5, 6, 7 & 8) into Point ID buses. This allows you to wire-
in a maximum of five Output Cards per ID bus (i.e. twenty in total)
• Wire-up zone (see wiring example below).
•
,
•
In engineer mode scroll to the Zone Menu . Press YES and scroll to Zone Hardware . Press YES again. Scroll down to
the zone you are interested in (e.g. in the wiring examples below you would select zone 5 and 6).
Scroll to Point ID . Then press YES. The system will automatically check the data bus for all Output Cards. When the
scanning finishes, quit from this branch of the menu....
1 Zone Names
2 Zone Types
3 Zone Options
4 Zone Gross & Pulse
5 Zone Hardware
6 Zone Block Assign
7 Technical Zone Options
8 Zone Power Supply Assign
9 Zone Map Menu
2 Devices Menu
1 Service Menu
3 Zone Menu
!
!
!
!
Aux 12V Remote Keypad
+ + B
- -
A
Point
ID Bus
Point
ID Bus
Point
ID Bus
Point
ID Bus
} } } }
ZONE 5 ZONE 6 ZONE 7 ZONE 8 ZONE 9 ZONE 10
OUTPUT 1
OUTPUT 5
OUTPUT 3
OUTPUTS
OUTPUT 7
OUTPUT 2
OUTPUT 6
OUTPUT 4
1 2 3 4 5 6 7 8
OUTPUT 8
DA
T
A
DATA
+
+
-
-
Tamper
Switch
Tamper
Switch
Status LED
Status LED
OPEN COLLECTOR
OUTPUT CARD
RELAY
OUTPUT CARD
1 Non EOL
2 Single EOL
3 Dual EOL 4K7
4 Point ID
5 RF Device