Hitachi CE50-10, Инструкция по эксплуатации

Страница: 180 / 194

Message ID Message Cause (meaning) Action
KXDL001-W Ethernet adapter( ethX ) Link is
down.
ethX : Interface name
Link disconnected 2. Check the LAN cable for a fault
(such as disconnection or loose
connection).
3. Confirm that the type of the LAN
cable (straight or cross) is correct.
If it is not correct, replace the
LAN cable.
4. Confirm that the communication
speed is correct. If it is not, match
the communication speed at the
connection destination.
5. If there are no problems in the
preceding items, a unit failure
might have occurred. Replace the
unit.
KXDL002-W
Ethernet adapter(
ethX
) collision
retry error.
ethX : Interface name
Collision retry error Traffic (communication load) is too
high.
1. Reduce the traffic because
processing delays might be caused
by a large amount of discarded
data due to collisions.
2. If this error frequently occurs
when traffic is low, confirm that
the communication speed is
correct. If it is not, match the
communication speed at the
connection destination.
3. If there is no problem in the
preceding items, a unit failure
might have occurred. Replace the
unit.
KXDL003-E Ethernet adapter( ethX ) PCIe Bus
Error:
severity=Uncorrected (Fatal).
ethX : Interface name
Bus error A PCI bus error was detected in the
unit. A unit failure might have
occurred. Replace the unit.
KXDL005-E
Ethernet adapter(
ethX
) initial
error.
ethX : Interface name
Initialization error An attempt to initialize the LAN
controller failed. Replace the unit
because the LAN controller is faulty.
KXDL006-E Ethernet adapter( ethX ) transmit
timeout error.
ethX : Interface name
Transmission
completion timeout
(transmission TI
monitoring timeout)
A data transmission timeout was
detected. Replace the unit because the
LAN controller is faulty.
KXDL009-E
Ethernet adapter(
ethX
) Duplicate
IP address.
ethX : Interface name
Duplicate IP address
(during initialization)
1. An invalid IP address might be
defined on the local host. Correct
the IP address definition file, and
then restart the unit.
2. A loop configuration network is
not supported. If the unit is
connected to the network that uses
a loop configuration, change the
network configuration.
KXDL010-W
Ethernet adapter(
ethX
) Duplicate
IP address.
ethX : Interface name
Duplicate IP address
(during online)
KXDL020-E
Ethernet adapter (
ethX
) transmit
queue Y timed out.
ethX : Interface name
Y : Queue number
Transmission queue
timeout A transmission queue timeout was
detected. Replace the unit because the
LAN controller is faulty.
E. Error Messages
164