Hirschmann PRS 40 EZ, Руководство оператора и по обслуживанию

Страница: 40 / 57

Operator’s / Service Manual, PRS 40 EZ
© PRS 40 EZ REV A 03/16/06 190201_A
34
10 RADIO MODULE
10.1 INSTALLATION
A receiver module must be installed into the PRS 40 EZ before a radio sensor can be set up or used.
The following is the procedure for installing the radio module.
Caution: Handle the module with care. The module can be damaged by static electricity. Take
proper precautions by removing any static electricity from your body. Do not remove the
board from its protective anti static bag until the time of installation.
1. Open the PRS 40 by loosening the 4 screws on the console lid.
2. Insert p/n 101646 radio module into the sockets on the PCB assembly. Align the pins and press
the radio module into place. Make sure that they are correctly aligned and that they are firmly
seated. The foam will hold the radio module in place, when radio module is installed.
Inspect the gasket for nicks
or other damages.
Radio Module sockets.
P/N 101646
Radio Module
Installed
Ensure the pins are correctly
aligned and that they are
firmly seated sockets.