Hirschmann PRS 40 EZ, Руководство оператора и по обслуживанию

Страница: 17 / 57

Angle
© PRS 40 EZ REV A 03/16/06 190201_A
11
1. Locate an appropriated flat surface area on the boom base section or luffing jib root section. Avoid
the installation close to moving parts or parts that could interfere during boom hoist up and down.
Lower the boom into position that will allow you to safely install the angle sensor.
Notes: The antenna must point down and not up. Do not install angle sensor on hot mounting
plate, temperatures greater than 125°F (52°C) this could damage the angle sensor and/or
transmitter.
2. Measure the boom angle by using a digital inclinometer (i.e. smart level) at the area selected in
step 1. Align the mounting plate as defined be the decal or so the mounting holes pointing down as
shown in the pictures above. Affix the mounting plate onto the area. Clean, prime, and paint the
mounting plate if necessary.
3. Remove the angle sensor cover by loosen the four screws in the cover. Check the gasket to insure
it is not damaged. Remove the batteries. Align the 4 holes with the mounting plate threaded holes
and screw the angle sensor onto the mounting plate by using the four screws supplied in the kit.
Attach the antenna to the connector by carefully rotating the antenna clockwise
4. On the console, setup the sensor by using the menu selection:
MENU SETUP/SENSORS/ANGLE 1 or 2. In the setup process you will be asked to insert the
batteries while the receiver searches for the transmitter. Install batteries correctly as shown on the
label in the battery compartment. When the sensor has been found, confirm the angle sensor has
been installed. Return angle sensor cover and tighten the four cover screws carefully.
5. On the console, calibrate the angle by using the menu selection:
MENU SETUP/SENSORS/ANGLE (1 or 2 as defined above)/ZERO POINT. After making this
selection, measure the boom angle by using a digital inclinometer (i.e. smart level), scroll to the
correct angle and press OK. The calibration and set up of the sensor is now complete.
6. Check the angle of the main boom at 0°, 40°, 60°, and 70° and compare it with the measure value.
It should be
±
1
°
. If it is incorrect, repeat step 5, calibrate the angle sensor again, and verify the
actual angle and/or use a different/higher angle (50°) to scroll to and match the angle.