Hirschmann PRS 40 EZ, Руководство оператора и по обслуживанию

Страница: 37 / 57

Line rider
© PRS 40 EZ REV A 03/16/06 190201_A
31
9.1.3.B LATTICE BOOM MACHINES
MAXIMUM
30
┐
Figure 6. Lattice Boom Linerider Installation.
WARNING: CONTACT CRANE MANUFACTURER FOR WELDING INSTRUCTION PRIOR TO
WELDING ON BOOM.
1. Select a location that the swing arm angle with respect to the boom will not exceed 30°(see
Figure 6). The linerider should be located as close to the boom tip as possible.
2. Construct two base plates. Size of base plates will be specific to the lattice structure and your
selected location.
a. The first base plate will be attached to the boom with the swing arm bolt affixed to the
center of the base plate.
b. The second base plate will be attached to the boom so that it supports the linerider when
not in use.
3. Affix the swing arm bolt to the center of the first base plate.
4. Affix the first base plate to the selected location on the lattice boom.
5. Attach the swing arm to the bolt.
6. Run the hoist line through the linerider.
7. Attach the swing arm to the linerider.
8. Ensure freedom of movement side to side
9. Attach the second base plate to the boom so the linerider rubber supports will touch the plate
when there is no load.
10. Connect linerider electrically with cable provided.
Note: It is recommended that this cable be routed through conduit to the linerider in a way that
best protects the cable from damage, and secured with tie straps.
11. Connect the linerider extension to the console cable at boom base with the 28ft extension
provided.
NOTE: Extra electrical extensions can be ordered if required.