Troubleshooting
119/142
netPLC C100 | Startup Guide
DOC090701UM02EN | Revision 2 | English | 2009-10 | Released | Public
© Hilscher, 2009
14 Troubleshooting
General
¾
Check, if the requirements for slot PLC operation are served:
Further information to this you find in section
System Requirements
on
page 19.
Cable
¾
Check that the pin occupation of the used cable is correct.
Configuration
¾
Check the configuration in the Master and the Slave device. The
configuration has to match.
Diagnostic using the System Configurator SYCON.net
With the menu
Online > Diagnosis
the diagnosis information of the device
is shown. The shown diagnostic information depends on the used protocol.
Note:
More information about the device diagnosis and its functions you
find in the operating manual of the corresponding fieldbus system.
Therefore refer to section
Documentations netPLC
on page 10.
