HIKVISION DS-7200HVI, Руководство пользователя, Страница: 18 / 171

User Manual of DS-7200HVI/HFI-SH Series DVR
17
No. Name Description
In PTZ control settings, press the REC button and then you can call a
PTZ preset by pressing Numeric button.
7 PLAY Button Entering the All-day Playback menu.
8 INFO Button Reserved.
9 VOIP Button
Selecting all items on the list;
In live view or playback mode, it can be used to switch between main
and spot video output.
10 MENU Button Back to the Main menu (after successful login).
Pressing and holding the button for 5 seconds will turn off audible key
beep.
11
PREV Button Switching between single screen and multi-screen mode.
12 DIRECTION/ENTER
Buttons
Navigating between different fields and items in menus.
In Playback mode, the Up and Down button are used to speed up and
slow down recorded video.
The Left and Right button will select the next and previous day of
recordings.
In live view mode, these buttons can be used to cycle through channels.
13 PTZ Button Enter the PTZ Control mode.
14 ESC Button Back to the previous menu
Pressing for arming/disarming the DVR in Live View mode.
15
RESERVED
Reserved.
16
F1 Button Selecting all items on the list when used in a list field.
In PTZ Control mode, it will turn on/off PTZ light.
17
PTZ Control Buttons
Adjusting the iris, focus and zoom of a PTZ camera.
18 F2 Button Cycle through tab pages.
Troubleshooting Remote Control:
Note: Make sure you have installed batteries properly in the remote control. And you have to aim the remote
control at the IR receiver on the front panel.
If there is no response after you press any button on the remote, follow the procedure below to troubleshoot.
Steps:
1. Go to Menu > Settings > General > More Settings by operating the mouse.
2. Check and remember device ID#. The default ID# is 255. This ID# is valid for all the IR remote controls.
3. Press the DEV button on the remote control.
4. Enter the device ID# from step 2.
5. Press the ENTER button on the remote.
If the remote control is operating properly, but there is still no response from the remote, please check the
following:
1. Batteries are installed correctly and the polarities of the batteries are not reversed.
2. Batteries are fresh and not out of charge.
3. IR receiver is not obstructed.
If the remote still can’t function properly, please change a remote and try again, or contact the device provider.
alarm shop