Hewlett Packard Enterprise ProLiant DL20 Gen10, Руководство по техническому обслуживанию и ремонту

Страница: 53 / 153

Procedure
1. If installed, remove the front bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack.
6. Remove the access panel.
7. Disconnect all existing optical drive cables.
8. Remove the optical drive from the optical drive bay.
Retain the screw for future use.
To replace the component, reverse the removal procedure.
Removing and replacing the media bay blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Removal and replacement procedures
53