Hettich BlueMax Mini Modular Plus, Руководство по эксплуатации

Страница: 58 / 88

58
Before working on the pneumatic system, clean the machine,
at least the work area, as described below.
• Depressurize compressed-air lines and hoses of the
pneumatic system.
• Carefully detach hoses. Escaping compressed air may swirl
up dust
• Protect air connections to prevent them from becoming
dirty (mask if necessary)
• Never mix up connections, plugs or switches. This will
inevitably result in malfunctions
• Always work with the greatest possible level of cleanliness
Servicing unit
The servicing unit keeps dirt, dust, water and oil droplets out
of the compressed air line. Always make sure the reservoir is
emptied in good time. The filter has no effect if the reservoir
becomes too full. This will result in malfunctioning and faster
wear to valves and cylinders. The necessary intervals must be
defined internally as they will largely depend on the quality of
compressed air provided.
Servicing units must be checked for water at the sight glass
every day.
NOTE
After completing all work, make sure all screws and lines
are securely connected on the compressed air systems.
Servicing unit
The servicing unit keeps dirt, dust, water and oil droplets out
of the compressed air line. Always make sure the reservoir is
emptied in good time. The filter has no effect if the reservoir
becomes too full. This will result in malfunctioning and faster
wear to valves and cylinders. The necessary intervals must be
defined internally as they will largely depend on the quality of
compressed air provided.
Servicing units must be checked for water at the sight glass
every day.
NOTE
After completing all work, make sure all screws and
lines are securely connected on the compressed air
systems.
6. Instructions on inspections
Inspections are measures for establishing and assessing the
actual condition of a machine and its components.
NOTE
Inspections are carried out as preventive maintenance
and to ensure your personal safety.
Failure to carry out an inspection in good time is deemed non
intended machine use.
The machine operator must check the machine on a daily
basis for externally visible faults and immediately rectify any
faults identified or, if this is not possible, report them.
The machine must only be operated if it is in proper working
order.
The machine's surroundings must be kept clean and clear
of stumbling hazards. Compressed-air hoses and suction
extraction hoses must be routed so as not to be in the way of
the machine operator and restrict movement.
The prescribed servicing work must be carried out at the
intervals shown. If necessary, the owner must define other
appropriate intervals or specify additional work.
During weekly cleaning work, all of the machine's components
should be checked for wear and damage wherever possible.
The sooner damage is identified, the less it will cost to repair.
Once fitted, check all screw connections for secure fit. This
applies in particular to all components exposed to dynamic
strain.
During monthly servicing work, carry out random checks on
screw connections exposed to dynamic strain.
Check safety guards at regular intervals (at least once a
month) for proper working order.
Check all electric cables and compressed-air hoses for
damage and secure fit.
Check cable glands at terminal boxes for proper sealing and
secure fit.
General
Regularly clean drilling dust off of the machine.
Regularly check electrical cables and compressed air lines.
Immediately replace faulty or damaged components. Only use
genuine replacement parts.
Servicing / care