Hettich BlueMax Mini Modular Plus, Руководство по эксплуатации, Страница: 32 / 88

32
Continuation stops - Precision adjustment
1. Precision adjustment on Y axis via hexagon head screw
Produce hole line drilling and push continuation stop
into hole line boring
3
. Push workpiece towards machine
centre so that the outer edge of drill hole
4
rests against
the continuation stop. Now tighten screws
5
2. Precision adjustment on X axis via hexagon socket screws
Undo the hexagon socket screws
6
and align the
continuation stop flush with the cross member
7
. Carry
out test drilling
8
. With a sliding calliper, measure the
distance between both drill holes
9
. The distance from
outside edge to outside edge of both drill holes must be 69
mm. If the distance is not correct, the X direction can be
adjusted via the small hexagon socket screw
0.
Carry out
another test drilling and remeasure the distance between
both drill holes.
NOTE
Accurate settings will give you good quality results.
Drilling depth setting
Fig. 18: Drilling depth setting
The drilling depth can be adjusted using screw
1
(1 turn =
1 mm). Carry out trial drilling. Repeat the setting process if
necessary.
Start up / trial run
3
4
Machine centre
Machine centre
5
8
6
7
0
9
1