Hettich BlueMax Mini Modular Plus, Руководство по эксплуатации, Страница: 33 / 88

33 33
Drum stop
Edge distances in System 32 are set by means of the stop pin
1
. Four stops are already preset at the following distances:
a. 13 mm
b. 22 mm
c. 37 mm
d. 57 mm
The fifth stop is empty and represents the machine's zero
position. This is the machine's zero point and is used for
resetting the digital display to zero.
For customised distances between 13 mm and 57 mm that
cannot be set with the drum stop, stop
1
can be set using the
digital display. To maintain the position and be able to reuse
it later on, the sliding block can be set against the stop with
screw
2
.
Locking lever for frequently used distances
Using the locking lever to the left hand side (as viewed from
the operator), frequently used dimensions can be set by means
of a locking lever
1
.
The machine then always travels to a stop
2
Hold-down clamp
The hold-down clamps (assembly) are pre-mounted.
The photograph shows the right-hand side of the hold-down
clamp, the hold-down clamp for the left-hand side is installed
the other way round.
1
Hold-down clamp, front
2
Hold-down clamp, rear
1
1
2
2
1
2
1
Fig. 19: Drum stop
Fig. 20: Hold-down clamps