Hettich BlueMax Mini Modular Plus, Руководство по эксплуатации, Страница: 44 / 88

44
3
4
2
1
2 4
6
5
Interchangeable drilling unit, 90°, 9 spindles
This interchangeable drilling unit is used for creating holes at
an angle of 90° (runners).
A maximum of 6 drill bits may be fitted with a maximum
diameter of 5 mm.
32 32 32 32 32 32 32 32
256
L
R
L
R
L
R
L
R
L
Drilling pattern
Changing interchangeable drilling units
Depending on application, the appropriate interchangeable
drilling unit must be fitted for drilling the required holes.
This example shows you how to change an interchangeable
drilling unit. When changing drilling units, we recommend
wearing safety gloves to prevent injuring yourself on the
sharp tools.
WARNING
Warning - Hand injuries!
Before resetting the machine, disconnect mains plug
and detach compressed air supply.
First undo star shaped grips
1
until tool slips down.
The safety catch
2
holds the interchangeable drilling unit
3
back to prevent it from falling. Lower interchangeable drilling
unit out of guide using grip
4
. While doing so, give safety
catch
2
a short downward turn.
Set the interchangeable drilling unit aside.
Cleaning
Before fitting the required interchangeable drilling unit, clean
mating faces
5
and drive sprocket
6
with a clean cloth.
NOTE
Soiling results in rapid drive component wear and leads to
malfunctions in the production process.
Setting up
Fig. 40: Interchangeable drilling unit, 9 spindles
Fig. 41: Changing interchangeable drilling units
Fig. 42: Changing interchangeable drilling units
Fig. 43: Cleaning interchangeable drilling unit