herdstar BinTrac Breeder Control, Руководство по эксплуатации

Страница: 16 / 52

Operation Manual
Version 2.0
16
Part Number MAN-000009
Startup
1. Inspect BinTrac installation on weigh bin and verify legs are evenly lifted and not binding.
2. Verify area under bin legs is free and clear of any material.
3. Check weighing accuracy
a. Have someone with known weight sit on bin cross-bar support as close to leg as possible to verify
bracket assembly is accurately measuring weight.
b. Repeat on each cross-bar support.
4. Important - Manually fill weigh bin with approximately 100 lbs. of feed to allow for overshoot and
ensure flowability of feed during unload process
.
5. Zero Inventory Bin.
a. Make sure weigh bin is empty and in the Gross weight mode on the Breeder Console. Hold on both
the
and keys until the display shows .
b. Record Zero __________ (empty weight of bin) by viewing in SETUP Menu
(Used for resetting the zero point of the scale if it is ever zeroed out with weight on the bin in the
future).
Note: The batch filling of Weigh Bin must be completed one hour prior to starting the batching of the
programmed feeding.
Operation
Press the SELECT key to select between Gross Weight and Batch Amount. The Gross Weight is the total material
remaining in the bin. The bar graph indicates the approximate level of the bin. The Batch Amount is remaining weight
left to batch to reach the Batch Target. Note: Batch Weight always starts at the Batch Target and counts down to “0”
weight. This provides the best means to display the amount left to batch.
Manual Batch Run
1. Press the key until is displayed.
2. Press SELECT to view the Batch Target Weight value.
3. Use the key to increase the value by 1.
4. Use the key to decrease the value by 1.
5. Press SELECT to display the batch run control status ( or ).
6. Use the or keys to enable or disable batch run control.
7. Press SELECT to start Batching if run was selected. The batch run will begin immediately.
Scheduled Batch Run
1. Press key until is displayed.
2. Use the key to select .
3. Press SELECT to view the hour and minute schedule.
4. Use the key to select hour and minute to schedule batch.
Note: This is a 24-hour clock (i.e. 13:00 = 1:00pm).
5. Press SELECT to view the Batch Target Weight value.
6. Use the key to increase the value by 1.
7. Use the key to decrease the value by 1.
8. Press SELECT to display the batch run control status ( or ).