herdstar BinTrac Breeder Control, Руководство по эксплуатации

Страница: 39 / 52

Operation Manual
Version 2.0
39
Part Number MAN-000009
Navigating Setup mode
To navigate through the options in SETUP mode, use the and keys to
cycle through the options/parameters. See the SETUP menu flow chart to the right.
Accessing the Setup mode
1. Press and hold the SELECT button down until is displayed.
Segmented display:
Enabling Peripherals in Setup mode
In the SETUP Mode, the four LEDs indicate configuration options as being enabled
(solid on) or disabled (flashing). For this configuration, only the RUN LED
should be solid on, enabling communication to peripherals.
GROSS WEIGHT
- Configures a BinTrac or Breeder Indicator as a Remote Display
automatically when connected to a Master Breeder Control with
Peripheral Devices enabled.
BATCH AMT - NOT USED
LED (left of RUN) - NOT USED
RUN - Enable communications to Peripheral devices. Must be enabled
when Breeder Control is connected to a Remote Display device
(REMOTE BinTrac Indicator or Breeder Control console)
2. Press the SELECT key four times and then press the key to enable Peripherals in the
SETUP mode (RUN LED will be on solid). Press the SELECT key and then will
be displayed.
Batch
Enables you to set the batch option to
LoAd or u.LoAd . In this configuration, the parameter MUST
be set for u.LoAd for the hen unload batching auger.
Segmented display:
3. Press the SELECT key to enter BATCH menu, and
.
should be displayed (If is displayed
press to set to
.
).
4. Press the SELECT key and then is shown.
5. Press and
. .
is displayed.
SETUP Menu
Flow Chart