16
Precautions
Precautions
Precautions
Precautions
①
The telephone used for programming set-up should be double
audio frequency telephone with accessible Internet. Please turn P/T
switch to “T” position.
②
The wireless receiving host should be set in disarm mode as
much as possible to prevent wireless signal from triggering an
interrupt.
③
During every step of set-up, telephone will give out sound
prompt.
A “beep” sound
－－
means the operation is valid.
Three “beep” sounds
－－
mean the operation is invalid.
④
When the host enters into setup mode, telephone is powered
by the receiving host, but it is limited by power supply current, so that
users fail to conduct programming set-up or can’t hear any sound
prompt through using “hand-free” function. Therefore, users shall
conduct programming set-up through telephone handset.
Programming
Programming
Programming
Programming Operation
Operation
Operation
Operation
How
How
How
How to
to
to
to Enter
Enter
Enter
Enter into
into
into
into Set-up
Set-up
Set-up
Set-up Mode
Mode
Mode
Mode
Make sure to well connect the receiving host and to connect the
telephone to the receiving host according to “Interface Performance
and System Connection” Section.
In Standby Mode:
Users shall hold down the set-up switch on the rear panel of the
receiving host for 2.5 seconds until the host gives out a “beep” sound,
and then input a six-number user password and press
“
#
”
key to
confirm it. Once the password is confirmed, the host will enter into
set-up mode.
The factory-set user password is “000000”. If the password is
confirmed, there will be a “beep” sound, and then users can go on the
next operations. Otherwise, the host will give out three “beep” sounds,
and in this case, users shall input password again after sound prompt.
