PRIMAAX
®
EX / PRIMAAX
®
for International Truck Vehicles
Component Replacement
56
17730-283
QUIK-ALIGN PIVOT BUSHING
DISASSEMBLY
You will need:
■
A vertical shop press with a capacity of at least 10 tons.
■
A QUIK-ALIGN pivot bushing installer, remover and receiver tool. See Special Tools Section
of this publication.
FIGURE 8-26
FIGURE 8-27
1. Remove the support beam
assembly. Follow the D-pin
Bushing Disassembly Step 1
through 8 in this section.
2. Center the push out tool on the
inner sleeve and press out the
old bushing, (these bushings
are not cartridge type bushings,
they do not have outer metals),
see Figure 8-26 and 8-27.
3. Clean and inspect the I.D. of the
support beam eye.
ASSEMBLY
NOTE DO
NOT
use petroleum or soap base lubricant, it can cause an adverse reaction with the
bushing material, such as deterioration.
1. Lubricate the bushing and the inner diameter of the support beam eye with light
Naphthenic Base Oil, such as 60 SUS at 100°F, see Figure 8-28.
2. Position the support beam on the receiving tool with the beam eye centered on the tool. Be
sure the support beam is squarely supported on the press bed.
3. Place the QUIK-ALIGN bushing installer tool (see Special Tools Section of this publication)
on the QUIK-ALIGN bushing, see Figure 8-29.
4. Press in the new bushing. Bushings must be centered within the support beam eye. When
pressing in the new bushings over-shoot desired final position by
3
⁄
16
" and press again from
the opposite side to center the bushing within the support beam eye bore, if necessary, see
Figure 8-30.
5. Install the support beam assembly. Follow D-pin Bushing Assembly Instructions, Steps 5
through 32 in this section.
FIGURE 8-28
FIGURE 8-29
FIGURE 8-30
Pro Gear and Transmission • 906 W. Gore St. Orlando, FL 32805 • 1 (877) 776-4600 / (407) 872-1901 • [email protected]
