HEIDELBERG Speedmaster CD 102, Руководство пользователя

Страница: 64 / 170

GR SG9015813000000000
GR SG9015812000000000
Preset Plus Feeder
confidential
C.1.26
7.2 Adjusting the sheet separator fingers
1
2
Fig. 27 Sheet separator finger – outer carrier air
blower
1
4 2 3
Fig. 28 Aligned sheet separator finger
Fitting the supports
1. Loosen the knurled head screw (Fig. 27/2).
2. Install the required sheet separator finger be-
tween knurled head screw and support.
3. Manually tighten the knurled head screw
(Fig. 27/2).
Adjusting the height
1. Adjust the height of the sheet separator finger
at the knurled nut (Fig. 27/1).
The distance between the upper edge of the sheet
and the sheet separator finger must be between 0
and 3 mm (Fig. 26/4).
Adjusting the distance to the pile
Note
Sheet separator fingers that protrude
too far into the pile can obstruct the
”leaping up” of sheets and lifting suck-
ers and thus trigger a missing sheet.
The press is switched off when a miss-
ing sheet is detected.
1. Loosen the knurled head screw (Fig. 27/2).
2. Move the sheet separator finger until it pro-
trudes into the pile by 2...10 mm (Fig. 26/5).
3. Position the sheet separator fingers, obliquely
towards the inside, underneath the carrier air
blowers (Fig. 28/1 through 4).
D
Inner sheet separator fingers (Fig. 28/2, 3)
Set the sheet separator fingers lightly to-
wards the inside, underneath the inner
carrier air blower.
D
Outer sheet separator fingers (Fig. 28/1, 4)
Set the sheet separator fingers lightly to-
wards the inside, underneath the outer
carrier air blowers.
4. Manually tighten the knurled head screw
(Fig. 27/2).