Heat & Glo • CERONA-36-IFT, CERONA-42-IFT Installation Manual • 2558-980 Rev. C • 3/21
46
STEP 3.
LOG #3 (SRV2106-705):
Place the “Y” portion
of the log in the grate tine and rest the log on the formed
portion of log #2. See Figure 4.
E. Positioning the Logs
Model: CERONA-36, CERONA-36-IFT
Log Assembly: LOGS-CERONA36
CAUTION:
Carefully remove the logs from the packaging.
Logs are fragile!
STEP 1.
LOG #1 (SRV2106-701):
Place the notch on the left underside of log #1, over the log tab that is located on
the right side of the pilot bracket. Move the right end of log #1 forward until it hits the stick on the burner. The closer the log
is to the burner the more glow you will get. Don’t place the log too close to the burner or sooting may occur. See Figure 2.
STEP 2.
LOG #2 (SRV2106-703):
Fit log #2 on the
top branch of log #1
(A)
. Rest the formed groove of the lower
part of the log on the grate. It may be necessary to tilt Log
#1 forward to properly engage with Log #2. See Figure 3.
11
22
33
Figure 1
Figure 2
Figure 3
Figure 4
66
11
22
55
33
44
A
A
FORMED
FORMED
GROOVE
GROOVE
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately,
refer to the following instructions.
