10
Place the A-501 Bore
Sweep Unit into the
A-502L and secure it
with the thumb screw.
Slide the Sliding Bore
Sweep Rod into the A-
501 Bore Sweep Unit.
Slide the indicator
push tab onto the rod
but do not tighten the
set screw. Slide the
Bore Sweep Rod tip
onto the rod so the
rounded tip is down
and toward the
reference bore. Place
the tip onto the bore
surface so it will hold
the rod from falling
out. The Bore Sweep Unit has a linear bearing slide so the rod cannot rotate when it is inserted into the
unit. Slide the indicator push tab up onto the rod until it compresses the indicator rod approximately half
way and then tighten the set screw against the rod.
Place the Bore Sweep Rod tip on one side near the top of
the reference bore and zero the Digital Dial Indicator by
pressing the yellow
Zero
button.
Содержание L-705
Страница 1: ......
Страница 18: ...15 Half Bore Alignment Setup...
Страница 27: ...24 Appendix B Configuring the R 1307 2 4ZB Readout Model R 1307 Readouts Control Panel...