HALYTECH
Illuminator User Manual
Page 23
Setting up Email Parameters
Email parameters need to be entered if you wish to send automatic e-mail reports or to
connect remotely to an Illuminator with your PC.
To set up E-mail parameters, access the “Change Setup” page as described in “Setting up an
Illuminator for the first time” earlier in this section.
Click on “Change Email Settings”.
Fill in the form with details appropriate for your network.
You will need to obtain this information from your network administrator or your mobile service
provider.
At the time this manual was issued, the correct settings for common Australian mobile
networks were:
Telstra SMTP mail server:
mail.bigpond.com
Optus SMTP mail server:
mail.optusnet.com.au
Vodafone SMTP mail server:
smtp.vodafone.net.au
“From” email address: In the process of sending an e-mail, the Illuminator must identify itself
to the mail host computer with a valid e-mail address. Set this parameter to a known valid
address, acceptable to your mail host. This address is shown in the e-mail as the “From”
address. If you are using a Telstra SIM card you can use [email protected]
NOTE: if the e-mail is accepted by the host but cannot be delivered, the failure notice will be
sent to this address
Test email address:
Test e-mails are sent to this address.
This is a special feature of the Illuminator allowing a rapid and user friendly way of setting up
and verifying Illuminator e-mail connectivity. Please refer to Appendix D for details.
IMPORTANT:
It is strongly advised that you confirm that all settings are correct. This done by
sending a test e-mail as described in Appendix D.
