2gig Technologies Vario, Руководство по установке

Страница: 1 / 6

Nortek Security & Control | 1950 Camino Vida Roble, Suite 150 | Carlsbad, CA 92008-6517 | USA | 800-421-1587 | www.nortekcontrol.com
Copyright © 2016 Nortek Security & Control LLC.
1
Installation Instructions
Tamp
er
DIP SW1
1 2 3 4
OPT N/A
Tes
t N/A
In
tr
nl MIC
B
yp
as
s
POWER
YEL GRN
BUS
BLK
COM
RED
AUX
BUS
AUX COM LED TMP
Voice
(to panel)
Out In1 In2 In3
Message Box Tes
t
Sp
k
r
LED1
Rec
Play
MIC1
VOICE MODULE
The 2GIG Vario Voice Module provides audible information about the status of the 2GIG Vario System, and enables any remote, touch-tone (DTFM) telephone to
act as a keypad for the system. When a system event occurs (such as an alarm activation) the Voice Module notifies a system user by calling a specified telephone
and playing a pre-recorded announcement.
NOTE: For instructions on how to program the Voice Module, see the 2GIG Vario System Installation Guide .
Installing the Voice Module
SW Description Usage
1 Omit Tamper Instead of a short with the TMP/COM terminal block
2 OPT N/A
3 Test
Connected in parallel to all output channels. It enables the user
to listed to all played messages using a speaker (at least 32
Ohm) connected between the Test Spkr and COM terminals.
4 Intern MIC
Select an external or internal microphone for recording
messages:
On: Enables recording messages from the microphone located
on the Voice Module board.
Off: Enables recording messages from a microphone located
on the 2GIG Vario Listen-in & Speak Module.
DIP Switches
2GIG® Vario System
2GIG Vario Voice Module
10012671 A