18 June 2016
X6-ElectroMod
A 160AH 1.5KW Electrical Power Generator for the BMW X6
pg. 5
Copyright © 2016, HallonPower. All content and images presented on this website are copyrighted © and all rights are reserved.
All manufacturer names, symbols, and descriptions, used in our images and text are used solely for identification purposes only. It is neither inferred nor
implied that any item sold here, is a product authorized by or in any way connected with any vehicle manufacturers displayed on this page. This document
may be modified at any time and without notice.
Fitting the System Panel into an BMW X6 E71
The solution is housed on a single plywood panel that fits snugly and discretely underneath the
trunk floor in the luggage compartment of your BMW X6 (also called the Trunk Floor
Compartment).
Before fitting the System Panel, the Luggage Compartment Pan (A) (part no. 51476981061) and
the Battery Cover (B) (part no. 51476981050) will have to be removed to make room for the
installation. These parts are found
under the trunk floor. Place these
items in storage as they will no
longer be needed.
A System Control Panel (SCP) is also included in the solution which is housed on the right hand
side of the trunk of the BMW X6, also discretely and seamlessly blended into the Right Flap (D)
found in the trunk.
The X6 Interior-Rear-Storage
Compartment Right (C) (part no.
51476981048)
sits right underneath
the Right Flap (D). All wiring from the
Trunk Floor Luggage Compartment,
where the solution is installed, will
have to pass through this Storage
Compartment (C) in order to connect
to the SCP (see section about the
System Control Panel).
For this reason a hole will need to be
opened on the front side of the
Storage Compartment (C), large
enough (about 8cm) for the connecting Powerpole plugs to pass through (the hole will be out of
sight, hidden below the trunk floor level and completely covered by the SCP which will be sitting
over it).
