18 June 2016
X6-ElectroMod
A 160AH 1.5KW Electrical Power Generator for the BMW X6
pg. 30
Copyright © 2016, HallonPower. All content and images presented on this website are copyrighted © and all rights are reserved.
All manufacturer names, symbols, and descriptions, used in our images and text are used solely for identification purposes only. It is neither inferred nor
implied that any item sold here, is a product authorized by or in any way connected with any vehicle manufacturers displayed on this page. This document
may be modified at any time and without notice.
q.
Connect a solar panel to the Solar Input socket on the SCP and
place the panel in the sun.
r.
The same indication remains on the Smartpass as before while an
additional indication is seen on the D250S.
Fig.10
7.
Parallel Switch
a.
Make sure the engine is off and that the BEP 701-MD is set in
automatic mode.
b.
Check the voltages for each battery bank on the Smartpass.
You should see 2 different voltages displayed.
c.
Push the Parallel button on the SCP. This should switch ON
‘Battery Parallel Mode’ via the BEP 701-MD Motorized Battery
Switch. Check to verify that the BEP 701-MD has turned to Auto
ON mode.
d.
Check the voltages for each battery bank on the Smartpass.
Allow up to 10 seconds for the charge to equalize. You should see
the same voltage displayed for both banks.
e.
Push the Parallel button on the SCP. This should switch OFF
‘Battery Parallel Mode’ via the BEP 701-MD Motorized Battery
Switch. Check to verify that the BEP 701-MD has turned to Auto
OFF mode.
f.
If you have a wireless remote control for your X6-Electromod,
repeat the above steps using it.
The M300, Smartpass, D250S, PureSine1500, Smartgauge and LED meters have a
number of error codes that may be indicated at times on their equipment. For a
complete list of these as well as more detailed information on these devices please
refer to their respective manual.
To ensure that your AGM batteries enjoy a long productive life, make sure you keep
them fully charged at all times, especially after a good workout.
Every 3 months or so you should also perform an equalizing charge to remove any
sulphate build up on the plates.
For more detailed information on each individual module,
please refer to their respective manual.
Congratulations! The X6-Electromod is now fully operational!
