18 June 2016
X6-ElectroMod
A 160AH 1.5KW Electrical Power Generator for the BMW X6
pg. 23
Copyright © 2016, HallonPower. All content and images presented on this website are copyrighted © and all rights are reserved.
All manufacturer names, symbols, and descriptions, used in our images and text are used solely for identification purposes only. It is neither inferred nor
implied that any item sold here, is a product authorized by or in any way connected with any vehicle manufacturers displayed on this page. This document
may be modified at any time and without notice.
F. Power Distribution Bottom Panel
1.
Then take the Power Distribution Bottom Panel, and lower it into position, underneath the
brackets protruding from the sides of the Power Distribution Vertical Panel. It should slide
with minimal effort into the grooves of the SP and the Power Distribution Vertical Panel.
Please note: Make sure that you lift the cables up through the large holes cut onto the Power
Distribution Bottom Panel before you place it into position. If required, use masking tape to
prevent them from dropping back down.
2.
Fasten the Power Distribution Bottom Panel onto the surrounding panels.
3.
Now fasten the back plates of the fuse boxes onto the SP (do not add the fuse boxes yet).
4.
Pass the thick black Inverter -ve cable (INV/N-SBB/N) through the rear opening of the Power
Distribution Vertical Panel.
5.
Hold the BEP701MD (octopus) with all attached cables, making sure that most cables are
facing forward (Only 3 cables should be facing the rear of the car).
6.
Start by passing the longest thick red cable (blue colour-coded - BEP/AB-AB coming out of
the back of the octopus) through the rear opening of the Power Distribution Vertical Panel.
Slide it all the way to the main car battery (Alternator Battery) and fasten it onto the
supplied bolt (you will need to cut a small opening on the plastic cover and a couple of
washers for the lug to sit properly).
7.
Then pass the other thickest red wire (red colour-coded - BEP/SBB-SBB coming out of the
front of the octopus) through the front opening on the Power Distribution Vertical Panel.
8.
Take the WAGO plug coming out of the octopus and pass it under the floor compartment
and into the Interior-Rear-Storage Compartment Right (C) through the hole on its front.
9.
Now you can fasten the BEP701 onto the Power Distribution Bottom Panel.
10.
Take the fuse boxes and remove the fuses from inside them. Connect one fuse box to each
one of the thinnest cables coming from the BEP. Connect the remaining empty slot of each
fuse box with the thinnest cables on LOOM1, making sure the colours match for both cables
connected to each fuse box (the order of the cables on each fuse box does not matter).
11.
Place the fuse box with the blue colour-coded cables (AB) and slot it in place on the left-
most slot, while the other one with the red colour-coded cables (SBB) should be slotted on
the right hand slot.
Please note: It really makes no difference where you slot the fuse boxes, but let's keep AB on
the left and SBB on the right to keep things organized.
12.
Now, place one 2cm washer on each of the 2 spacer bolts attached to the Power Distribution
Bottom Panel.
